Rubber Cracker YWIN
1.Rolls are chilled cast iron roll. We have diverse configuration , just inform me your prerequisite
two.Characteristic and Structure
This is a double roll rubber-mixing machine. It consists of motor, equipment-down reducer, driving gears, velocity-ratio gears, entrance and back rolls, bearings, body, go over, bed plate, modifying pin unit, unexpected emergency end gadget, roll temperature modifying device, lubricating gadget and content plate, and many others.
Entrance and back again rolls are parallel mounted in the bearing of frame. By implies of reducer, driving gears, pace ratio gears, the motor drives the front and back again rolls rotate towards each and every other so that rubber-cracking is started. The rolls are made from chilled forged alloy iron the internal of it is hollow. Steam and cooling h2o can pass by way of them so that the surface temperature can be altered. Its floor possesses larger hardness and fineness.
Roller bearing, copper bushing is fixed in the bearing foundation of body. Back again roll bearing bases are set up on frame, and the front roll-bearing foundation can slide in the information-rail of body.
Roll spacing changing is carried out by means of the reverse of hand wheel makes the thread rod generate entrance bearing base motion. The roll pin decreases when the hand wheel rotates clockwise, or else it will boost.
The unexpected emergency halting unit is mounted in the frame. In irregular situation, pulling the rod, via dynamic, the machine is stopped quickly.
Changing temperature unit is two spray pipes with numeral rows of holes, extend the two pipes into the hollow roll, the holes are in the placement of functioning segment of the roll. The situation of holes slants to 30 diploma inner course so that the spraying drinking water and steam is directed at getting in contact with angle of sizing material, this can control the area temperature of roll.
Parameter Of Rubber Cracker YWIN
Kind Technological parameter |
XKP-four hundred |
XKP-450 |
XKP-560 |
Entrance roll diameter(mm) | 400 | 450 | 560 |
Rear roll diameter(mm) | four hundred(Groove roller) | 450(Groove roller) | 510(Groove roller) |
Doing work length of rolls(mm) | 600 | 650 | 800 |
Front roll surface area speed(m/min) | seventeen.32 | 23.two | 24.fifty six |
Friction ratio | one:1.38 | one:one.38 | one:one.30 |
Max.nip(mm0 | 8 | eight | fifteen |
Motor energy | forty five | 55 | 75 |
Overall dimension: length×Width×Height(mm) | 3950×1800×1780 | 4770×1846×1835 | 5064×2284×1978 |