Horizontal Chemical Water Multistage Single Suction Centrifugal Pump

Horizontal Chemical Water Multistage Single Suction Centrifugal Pump

Transient introduction:
D(DF) collection is a centrifugal pump of horizontal,solitary suction,multistage and sectional construction.It owns the attributes of high effectiveness,extensive performance range,sleek procedure,reduced sounds,straightforward maintenance…D(DF) sequence was made to pump clean water or fluids have shut characters of water. Also,by altering pump wetted elements,it is in a position to pump fluids like very hot drinking water,oil,corrosive fluids and fluids particles. 

Parameters:

  1. Flow rate:Q=20~540m3/h
  2. Total head:H=sixteen~370m
  3. Velocity:n=1450rpm/2950rpm
  4. S.g.:γ ≤1.fifteen
  5. Temperature:T=-~80ºC
  6. Pump diameter:80,one hundred,a hundred twenty five,a hundred and fifty,two hundred,250mm

Characteristics:

  1. YWINd hydraulic models with high efficiency and wide performance range.
  2. Smooth operation and low noise.
  3. Both packing seal and mechanical seal are available.
  4. Completely sealed shaft which is non-contact with fluid.
  5. The pump material can be changed to pump corrosive fluids. D(F) stands for a pump which is suitable for corrosive fluids,but its performance and is totally the same to D series.

Composition:

  1. The pump set mainly consists of bearing housing,inlet and out section,middle section,guide vanes.
  2. The pump inlet is horizontal and outlet is verticalThe balance hose on the inlet is connected back to the water inlet side.
  3. Between bearings structure.The rotary part consists of shaft,impellers and a balance disk.
  4. The gaps between pump inlet section,middle section and outlet section are smeared by molybdenum disulfide compound calcium-based lubricating grease as the sealings. The gaps of rotary part and static part are sealed seal rings,guide vane sleeve and packing.
  5. YWIN shaft sealing is packing,can be customized as mechanical seal. 

Structure drawing is as below

1. Inlet section 2. Guide vane 3. Middle section 4. Outlet section 5. First-stage impeller 6. Impeller 7. Balance disk 8. Balance plate 9. End cover 10. Packing 11. Balance sleeve 12. Packing gland 13. O ring 14. Bearing 15. First-stage seal ring 16. Seal ring 17. Guide vane sleeve 18. Shaft 19. Shaft sleeve

Configuration:

Software:

  1. Widely used in mining,factories and city water supply and drainage.
  2. Suitable to pump clean water and fluids have close physical and chemical characters of water,or fluids like hot water,oils,corrosive material and particles.

 

Horizontal Chemical Water Multistage Single Suction Centrifugal Pump

TAGs: