High Head Multistage Pump, High Pressure Multistage Water Pump

High Head Multistage Pump, High Pressure Multistage Water Pump

Transient introduction:
D(DF) collection is a centrifugal pump of horizontal,one suction,multistage and sectional structure.It owns the functions of substantial effectiveness,wide performance assortment,easy operation,minimal sound,easy upkeep…D(DF) series was developed to pump clean drinking water or fluids have near characters of drinking water. Also,by altering pump wetted components,it is in a position to pump fluids like scorching water,oil,corrosive fluids and fluids particles. 

Parameters:

  1. Flow rate:Q=20~540m3/h
  2. Total head:H=sixteen~370m
  3. Pace:n=1450rpm/2950rpm
  4. S.g.:γ ≤1.15
  5. Temperature:T=-~80ºC
  6. Pump diameter:80,a hundred,125,150,two hundred,250mm

Characteristics:

  1. YWINd hydraulic models with high efficiency and wide performance range.
  2. Smooth operation and low noise.
  3. Both packing seal and mechanical seal are available.
  4. Completely sealed shaft which is non-contact with fluid.
  5. The pump material can be changed to pump corrosive fluids. D(F) stands for a pump which is suitable for corrosive fluids,but its performance and is totally the same to D series.

Framework:

  1. The pump set mainly consists of bearing housing,inlet and out section,middle section,guide vanes.
  2. The pump inlet is horizontal and outlet is verticalThe balance hose on the inlet is connected back to the water inlet side.
  3. Between bearings structure.The rotary part consists of shaft,impellers and a balance disk.
  4. The gaps between pump inlet section,middle section and outlet section are smeared by molybdenum disulfide compound calcium-based lubricating grease as the sealings. The gaps of rotary part and static part are sealed seal rings,guide vane sleeve and packing.
  5. YWIN shaft sealing is packing,can be customized as mechanical seal. 

Structure drawing is as below

one. Inlet section 2. Guide vane 3. Middle section 4. Outlet section 5. First-stage impeller 6. Impeller 7. Balance disk 8. Balance plate 9. End cover 10. Packing 11. Balance sleeve 12. Packing gland 13. O ring 14. Bearing 15. First-stage seal ring 16. Seal ring 17. Guide vane sleeve 18. Shaft 19. Shaft sleeve

Configuration:

Application:

  1. Widely used in mining,factories and city water supply and drainage.
  2. Suitable to pump clean water and fluids have close physical and chemical characters of water,or fluids like hot water,oils,corrosive material and particles.

 

High Head Multistage Pump, High Pressure Multistage Water Pump

TAGs: